Chrysler Sebring 2004 Service Manual page 1290

JR
GEAR SHIFT MECHANISM
REMOVAL
(1) Disconnect battery negative cable.
(2) Remove gearshift knob/boot assembly.
(3) Remove center console assembly (Fig. 80).
Fig. 80 Center Console Assembly—Typical
1 - CENTER CONSOLE
2 - SCREW
3 - IF EQUIPPED
4 - IF EQUIPPED
5 - PARK BRAKE HANDLE
(4) Disconnect crossover cable from mechanism.
(5) Disconnect selector cable from mechanism.
(6) Remove crossover and selector cable retaining
clips (Fig. 81) from mechanism and disconnect cables.
Fig. 81 Cable Retaining Clips
1 - CABLE CLIPS
2 - SHIFTER
T350 MANUAL TRANSAXLE
(7) Remove shift mechanism-to-floor pan bolts and
remove mechanism (Fig. 82).
Fig. 82 Gearshift Mechanism
1 - GEARSHIFT MECHANISM
2 - NUT (5)
3 - GEARSHIFT CABLES
INSTALLATION
(1) Install gear shift mechanism to floor pan (Fig.
82). Install and torque four (4) nuts to 25 N·m (18 ft.
lbs.).
(2) Install crossover and selector cables into posi-
tion. Secure with retaining clips (Fig. 83).
Fig. 83 Crossover and Selector Cables at Shift
Mechanism
1 - CABLE CLIPS
2 - SHIFTER
3 - ADJUSTMENT SCREW
NOTE: Only the crossover cable is adjustable. The
selector cable does not have any adjustment capa-
bilities.
21 - 29