Table of Contents
Advertisement
21 - 92
T850 MANUAL TRANSAXLE
INPUT SHAFT (Continued)
(11) Stake 5th Gear nut in four (4) places as fol-
lows:
(a) Install staking tool 8479 to 5th gear nut.
(b) Tighten upper thumb screw by hand (Fig.
124).
(c) Tighten two (2) side thumb screws by hand.
(d) Tighten both staking screws until they bot-
tom on tool body (Fig. 125).
(e) Loosen staking screws and thumb screws.
Remove tool and visually inspect stake (Fig. 126).
(f) Remove tool, rotate 90°, and repeat process to
stake in four (4) places.
Fig. 124 Staking Tool Set-Up
1 - STAKING TOOL 8479
2 - THUMB SCREWS (3)
NOTE: The input shaft sealed roller bearing and
snap ring do not get installed until transaxle assem-
bly to facilitate installation of the reverse idler gear
mechanism.
Fig. 125 Tighten Stake Screws
1 - STAKING TOOL 8479
Fig. 126 5th Gear Nut Stake (Four Places)
1 - STAKE
JR
Advertisement
Table of Contents
