Chrysler Sebring 2004 Service Manual page 1253

19 - 32 PUMP
PUMP (Continued)
Fig. 5 Pump Bracket Mounting - 2.7L Engine
1 - CAST PUMP MOUNTING BRACKET
2 - STAMPED PUMP ADJUSTER BRACKET
3 - POWER STEERING PUMP
4 - PIVOT BUSHING
(10) Remove three bolts fastening cast power
steering pump bracket to the engine (Fig. 5).
(11) Remove power steering pump, pulley and
brackets as an assembly from the engine. Remove
pump through opening between frame rail and right
driveshaft.
(12) Remove stamped adjuster bracket mounting
bolts. Remove bracket from pump.
(13) Remove two pivot bolts. Remove cast mount-
ing bracket from pump.
(14) For removal of pulley, (Refer to 19 - STEER-
ING/PUMP - DISASSEMBLY).
DISASSEMBLY - PUMP (PULLEY)
(1) Remove power steering pump from engine.
(Refer to 19 - STEERING/PUMP - REMOVAL)
CAUTION: Do not hammer on power steering pump
pulley or shaft to remove power steering pump pul-
ley. This will damage the pulley and the power
steering pump.
(2) Mount Puller, Special Tool C-4333, on power
steering pump pulley. Mount puller (with power
steering pump) in a vise (Fig. 6). This will keep shaft
of power steering pump from turning while removing
pulley.
(3) Tighten puller and remove pulley from shaft of
power steering pump.
Fig. 6 Removing Pulley From Power Steering Pump
1 - SPECIAL TOOL C-4333
2 - POWER STEERING PUMP PULLEY
3 - VISE
NOTE: Replace power steering pump pulley if bent,
cracked, or loose.
ASSEMBLY - PUMP (PULLEY)
CAUTION: Do not hammer on power steering pump
pulley or shaft to install power steering pump pul-
ley. This will damage the pulley and the power
steering pump.
(1) Place power steering pump pulley squarely on
end of power steering pump shaft (Fig. 7).
Fig. 7 Pulley Positioned On Shaft Of Power Steering
Pump (Typical)
1 - POWER STEERING PUMP PULLEY
2 - POWER STEERING PUMP
3 - POWER STEERING PUMP PULLEY MUST BE STARTED
SQUARELY ON SHAFT OF POWER STEERING PUMP AS
SHOWN
Shaft
JR