Chrysler Sebring 2004 Service Manual page 1668

JR
QUARTER PANEL WEATHERSTRIP (Continued)
INSTALLATION
(1) Position panel weatherstrip onto vehicle.
(2) Install weatherstrip to door opening flange.
(3) Install push in fasteners attaching weather-
strip to B-pillar.
(4) Install door sill trim panel.
QUARTER PANEL OUTER BELT
WEATHERSTRIP/MOLDING
REMOVAL
(1) Lower convertible top to midway position.
(2) Lower quarter glass to full down position.
(3) Remove quarter trim panel.
(4) Remove screws attaching quarter panel outer
belt weatherstrip/molding to outer quarter panel.
(5) Loosen appropriate side of upper deck molding.
(6) Pull upward at one end of outer belt weather-
strip to separate from vehicle.
(7) Remove outer belt weatherstrip from vehicle.
INSTALLATION
(1) Position quarter panel outer belt weatherstrip/
molding on vehicle.
(2) Push outer belt weatherstrip/molding down-
ward until weatherstrip/molding is fully seated.
(3) Install screws attaching outer belt weatherstrip
to outer quarter panel.
(4) Tighten fasteners for upper belt molding.
(5) Install quarter trim panel.
(6) Raise and secure convertible top.
REAR DOOR B-PILLAR DOOR
SEAL
REMOVAL
(1) Using a suitable heat gun, warm seal to
approximately 100° F to ease adhesive separation.
(2) Peel B-pillar seal from upper door frame, top to
bottom (Fig. 18).
(3) Clean adhesive residue from door frame.
INSTALLATION
(1) If original seal is reused, clean adhesive resi-
due from back of seal.
(2) Apply body side molding tape to back of seal.
(3) Peel protective paper from back of tape.
(4) Place cutout in seal around screw head at bot-
tom of seal location.
(5) Align seal to edge of door frame.
(6) Press adhesive onto door frame.
WEATHERSTRIP/SEALS
Fig. 18 Rear Door B-Pillar Seal
1 - B-PILLAR SEAL
REAR DOOR GLASS RUN
WEATHERSTRIP
REMOVAL
(1) Remove door glass. (Refer to 23 - BODY/
DOORS - REAR/DOOR GLASS - REMOVAL)
(2) Pull glass run weatherstrip from door glass
opening frame (Fig. 19).
Fig. 19 Door Glass Run Weatherstrip
1 - GLASS RUN WEATHERSTRIP
2 - REAR DOOR
INSTALLATION
(1) Install glass run weatherstrip to door glass
opening frame.
(2) Install door glass. (Refer to 23 - BODY/DOORS
- REAR/DOOR GLASS - INSTALLATION)
23 - 141