Chrysler Sebring 2004 Service Manual page 1344

JR
FLUID (Continued)
STANDARD PROCEDURE - FLUID DRAIN AND
FILL
NOTE: For proper fluid change intervals, (Refer to
LUBRICATION & MAINTENANCE/MAINTENANCE
SCHEDULES - DESCRIPTION)
The fluid required in this transaxle is Mopar
ATF+4. Use of substitute fluids may result in
improper transaxle operation and/or failure.
FLUID DRAIN
(1) Raise vehicle on hoist.
(2) Remove transaxle drain plug (Fig. 95) and
drain fluid into suitable container.
(3) Install drain plug and torque to 23 N·m (17 ft.
lbs.).
Fig. 95 Transaxle Drain Plug
1 - TRANSAXLE DRAIN PLUG
2 - DIFFERENTIAL COVER
FLUID FILL
(1) Remove transaxle fill plug (Fig. 96).
(2) Add 2.4-2.7L (2.5-2.9 qts.) of Mopar
until fluid is within 3/16" below fill hole.
(3) Install fill plug, ensuring it is properly seated.
(4) Lower vehicle.
GEAR SHIFT CABLE
REMOVAL
(1) Disconnect battery negative cable.
(2) Remove gearshift knob/boot assembly. Lift boot
off of console and disengage knob retainers to free.
(3) Remove center console assembly (Fig. 97).
1 - FILL PLUG
2 - END COVER
ATF+4
Fig. 97 Center Console Assembly—Typical
1 - CENTER CONSOLE
2 - SCREW
3 - IF EQUIPPED
4 - IF EQUIPPED
5 - PARK BRAKE HANDLE
(4) Disconnect crossover and selector cables from
shift mechanism.
T850 MANUAL TRANSAXLE
Fig. 96 Transaxle Fill Plug
21 - 83