Table of Contents
Advertisement
DRIVEABILITY - GAS
P0201-INJECTOR #1 CONTROL CIRCUIT 2.7L —
P0206-INJECTOR #6 CONTROL CIRCUIT 2.7L
When Monitored: With battery voltage greater than 12 volts. Auto Shutdown Relay
energized. Engine speed less than 3000 rpm.
Set Condition: No inductive spike is detected after injector turn off.
GOOD TRIP EQUAL TO ZERO
ASD RELAY OUTPUT CIRCUIT
FUEL INJECTOR
NOISE SUPPRESSOR(S) SHORTED TO GROUND
(A142) ASD OUTPUT OPEN
FUEL INJECTOR DRIVER CIRCUIT OPEN
FUEL INJECTOR DRIVER CIRCUIT SHORTED TO GROUND
PCM
TEST
1
NOTE: Record the Freeze Frame Information that set along with the DTC.
Turn the ignition on.
With the DRBIII , read DTC's.
Is the Good Trip displayed and equal to zero?
Yes → Go To 2
→ Refer to the INTERMITTENT CONDITION symptom in the
No
2
Turn the ignition off.
Disconnect the Fuel Injector harness connector.
Turn the ignition on.
With the DRB, actuate the ASD Relay.
Using a 12-volt test light connected to ground, probe the (F42) ASD Relay Output
circuit in the Fuel Injector harness connector.
Does the test light flash brightly?
Yes → Go To 3
→ Go To 7
No
POSSIBLE CAUSES
ACTION
Driveability category.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
Continued
92
APPLICABILITY
All
All
Advertisement
Table of Contents
