Chrysler Sebring 2004 Service Manual page 2094

P1192-INLET AIR TEMP SENSOR VOLTAGE LOW —
TEST
4 Turn the ignition off.
Disconnect the IAT Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance between the (K21) IAT Sensor Signal circuit and the (K4)
Sensor ground circuit in the IAT Sensor harness connector.
Is the resistance below 100 ohms?
Yes → Repair the short to (K4) Sensor ground circuit in the (K21) IAT
→ Go To 5
No
5 NOTE: Before Continuing: Disconnect the PCM harness connector and
check the related wiring terminals for corrosion, damage or terminal push
out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and connectors. Pay
particular attention to all Power and Ground circuits.
If there are no possible causes remaining, view repair.
Repair
ACTION
Sensor Signal circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
Replace and program the Powertrain Control Module in accor-
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
DRIVEABILITY - GAS
165
Continued
APPLICABILITY
All
All