Chrysler Sebring 2004 Service Manual page 1644

JR
SEAT BACK RECLINER (Continued)
Fig. 35 Recliner Housing
1 - UPPER RECLINER MECHANISM
2 - RECLINER HOUSING
3 - RECLINER CABLE
INSTALLATION
INSTALLATION
(1) Place seat recliner in position.
(2) Install manual recliner right and left bolts.
(3) Install seat back.
(4) Install recliner.
(5) Install bolt to attach seat back recliner to seat
back on each side of seat. Tighten recliner bolt to 12
N·m (9 ft. lbs.) torque. Tighten pivot bolts to 40 N·m
(30 ft. lbs.) torque.
(6) Remove seat cushion side shield.
(7) Install recliner handle.
(8) Install front seat in vehicle.
INSTALLATION - JR-27 ONLY
(1) Feed upper recliner mechanism and then
recliner housing into the seat back frame with han-
dle shaft facing the front of the seat frame.
(2) Install new bolts to attach seat recliner hous-
ing to seat frame. Tighten to 34 N·m (300 in. lbs.)
torque.
(3) Pull upper recliner mechanism through hole in
seat frame.
(4) Install screws attaching upper recliner mecha-
nism to seat frame.
(5) Install rubber bellows covering lower part of
seat back frame.
(6) Install seat back cover.
(7) Install recliner spring bracket, spring, and lead
screw.
(8) Install seat back to lower seat frame(Refer to
23 - BODY/SEATS/SEAT BACK - INSTALLATION).
(9) Install recliner handle.
(10) Install seat into vehicle(Refer to 23 - BODY/
SEATS/SEAT - INSTALLATION).
SEATS 23 - 117