Chrysler Sebring 2004 Service Manual page 1386

JR
41TE AUTOMATIC TRANSAXLE (Continued)
(26) Remove rear sun gear and #7 needle bearing
(Fig. 35).
NOTE: The number 7 needle bearing has three anti-
reversal tabs and is common with the number five
and number two position. The orientation should
allow the bearing to seat flat against the rear sun
gear (Fig. 36). A small amount of petrolatum can be
used to hold the bearing to the rear sun gear.
Fig. 35 Remove Rear Sun Gear
1 - #7 NEEDLE BEARING
2 - REAR SUN GEAR
Fig. 36 Number 7 Bearing
1 - #7 NEEDLE BEARING
2 - REAR SUN GEAR
41TE AUTOMATIC TRANSAXLE
(27) Setup tool 5058 as shown in (Fig. 37). Com-
press 2/4 clutch return spring (just enough to remove
snap ring) and remove snap ring.
NOTE: Verify that Tool 5058 is centered properly
over the 2/4 clutch retainer before compressing. If
necessary, fasten the 5058 bar to the bellhousing
flange with any combination of locking pliers and
bolts to center the tool properly.
Fig. 37 Remove 2/4 Clutch Retainer Snap Ring
1 - TOOL 5058
2 - SCREWDRIVER
3 - SNAP RING
4 - 2/4 CLUTCH RETAINER
(28) Remove 2/4 clutch retainer (Fig. 38).
Fig. 38 2/4 Clutch Retainer
1 - 2/4 CLUTCH RETAINER
2 - 2/4 CLUTCH RETURN SPRING
21 - 125