Chrysler Sebring 2004 Service Manual page 2072

Symptom:
P0443-EVAP PURGE SOLENOID CIRCUIT
When Monitored and Set Condition:
P0443-EVAP PURGE SOLENOID CIRCUIT
When Monitored: The ignition on or engine running. Battery voltage greater than 10
volts.
Set Condition: The PCM will set a trouble code if the actual state of the solenoid does not
match the intended state.
GOOD TRIP EQUAL TO ZERO
(K52) EVAP PURGE SOLENOID CONTROL CIRCUIT OPEN
(K52) EVAP PURGE SOLENOID CONTROL CIRCUIT SHORTED TO GROUND
(K108) EVAP PURGE SOLENOID SENSE CIRCUIT OPEN
(K108) EVAP PURGE SOLENOID SENSE CIRCUIT SHORTED TO GROUND
EVAP PURGE SOLENOID
EVAP PURGE SOLENOID LEAKS/STUCK OPEN
EVAP PURGE SOLENOID STUCK CLOSED
PCM
TEST
1 Turn the ignition on.
With the DRBIII , read DTC's.
Is the Good Trip Counter displayed and equal to zero?
Yes → Go To 2
→ Refer to the INTERMITTENT CONDITION symptom in the
No
2 Turn the ignition off.
Disconnect the Evap Purge Solenoid harness connector.
Disconnect the Powertrain Control Module harness connectors.
Measure the resistance of the (K52) Evap Purge Solenoid Control circuit from the
PCM harness connector to the Evap Purge Solenoid harness connector.
Is the resistance below 5.0 ohms?
Yes → Go To 3
→ Repair the open in the (K52) Evap Purge Solenoid Control circuit.
No
POSSIBLE CAUSES
ACTION
Driveability category.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
DRIVEABILITY - GAS
143
APPLICABILITY
All
All