Chrysler Sebring 2004 Service Manual page 2141

DRIVEABILITY - GAS
P1595-SPEED CONTROL SOLENOID CIRCUITS —
TEST
1 Turn the ignition on.
With the DRBIII , read DTC's.
Is the Good Trip displayed and equal to zero?
Yes → Go To 2
No
2 Turn the ignition on.
NOTE: In the below step you will need to actuate both S/C solenoids
separately. Note the operation of the each solenoid when actuated.
With the DRBIII , actuate the Speed Control Vacuum Solenoid and note operation.
With the DRBIII , actuate the Speed Control Vent Solenoid and note operation.
Choose the conclusion that best matches the solenoids operation?
Vacuum Solenoid not operating
Vent Solenoid not operating
Both S/C Solenoids not operating
Both S/C Solenoids operating
3 Turn the ignition off.
Disconnect the Speed Control Servo harness connector.
Turn the ignition on.
With the DRBIII , actuate the Speed Control Vacuum Solenoid.
Using a 12-volt test light connected to 12-volts, probe the Speed Control Vacuum
Solenoid Control circuit.
Does the test light illuminate brightly and flash?
Yes → Replace the Speed Control Servo.
No
4 Turn the ignition off.
Disconnect the S/C Servo harness connector.
Disconnect the PCM harness connector.
Measure the resistance of the (V36) Speed Control Vacuum Solenoid Control circuit
between the PCM harness connector and Speed Control Servo harness connector.
Is the resistance below 5.0 ohms?
Yes → Go To 5
No
ACTION
→ Refer to the INTERMITTENT CONDITION symptom in the
Driveability category.
Perform POWERTRAIN VERIFICATION TEST VER - 4.
Go To 3
Go To 7
Go To 11
Go To 16
Perform POWERTRAIN VERIFICATION TEST VER - 4.
→ Go To 4
→ Repair the open in the (V36) Speed Control Vacuum Solenoid
Control circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 4.
212
Continued
APPLICABILITY
All
All
All
All