Chrysler Sebring 2004 Service Manual page 1259

Table of Contents

Advertisement

19 - 38
PUMP
HOSE - SUPPLY (Continued)
(5) Remove hose clamp attaching supply hose to
reservoir, then remove supply hose from reservoir
(Fig. 12).
(6) Remove hose clamp attaching supply hose to
power steering pump supply fitting, then remove
supply hose from supply fitting (Fig. 13) (Fig. 14).
Fig. 13 Pump Mounting To Engine (2.0L/2.4L)
1 - DRIVE BELT
2 - PULLEY
3 - PRESSURE HOSE
4 - POWER STEERING PUMP
5 - SUPPLY HOSE
(7) Remove supply hose from vehicle.
INSTALLATION
(1) Install supply hose down past engine and onto
power steering pump supply fitting (Fig. 13) (Fig.
14). Install clamp.Be sure hose clamp is installed
on hose past upset bead on fitting.
(2) Install power steering fluid supply hose onto
power steering fluid reservoir fitting (Fig. 12). Install
clamp. Be sure hose clamp is installed on hose
past upset bead on power steering reservoir fit-
ting.
(3) Slide reservoir down over guide on engine cool-
ant recovery bottle.
(4) Install power steering fluid reservoir mounting
screw and tighten to 6 N·m (53 in. lbs.).
(5) Install remote battery ground cable on ground
stud located on left shock tower.
Fig. 14 Pump Mounting To Engine (2.7L)
1 - SUPPLY HOSE
2 - DRIVE BELT
3 - PULLEY
4 - PRESSURE HOSE
5 - POWER STEERING PUMP
(6) Fill power steering pump fluid reservoir to the
proper level.
(7) Start the engine and let run for a few seconds,
then turn the engine off.
(8) Fill power steering pump fluid reservoir to the
proper level and perform Power Steering Pump Ini-
tial Operation standard procedure. (Refer to 19 -
STEERING/PUMP - STANDARD PROCEDURE)
(9) Check for leaks.
RESERVOIR
DESCRIPTION
All vehicles use a remote mounted power steering
fluid reservoir. The reservoir is mounted to the
engine coolant recovery bottle on the right side of the
engine compartment (Fig. 12). Coolant level is read
through the side of the bottle.
REMOVAL
(1) Remove remote ground cable from ground stud
on left shock tower. Isolate ground cable from vehicle
by placing isolator on stud as shown (Fig. 10).
JR

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sebring convertible 2004Stratus 2004

Table of Contents