Table of Contents
Advertisement
21 - 220
41TE AUTOMATIC TRANSAXLE
SHIFT INTERLOCK CABLE (Continued)
(6) Remove fuse panel cover from left end of
instrument panel. Remove screw holding end of
instrument panel top cover (Fig. 281).
Fig. 281 Instrument Panel Top
1 - FUSE PANEL COVER
2 - SCREW
(7) Remove lower knee bolster screws and knee
bolster.
(8) Remove steering column lower shroud (Fig.
282).
Fig. 282 Steering Column Lower Shroud
1 - STEERING COLUMN LOWER SHROUD
2 - IGNITION CYLINDER
(9) Tilt wheel to full down position and remove
upper steering column shroud.
(10) Disconnect interlock solenoid connector.
(11) Disconnect nylon cable retainer from lower
column mounting stud.
(12) Place the ignition key in the ON/RUN position
(Fig. 283). Grasp the interlock cable clip and connec-
tor. Remove the cable from the interlock housing
(Fig. 284).
Fig. 283 Ignition Key/Switch Positions
1 - ACC
2 - LOCK
3 - OFF
4 - ON/RUN
5 - START
Fig. 284 Interlock Cable and Connector
1 - IGNITION LOCK CYLINDER
2 - INTERLOCK CABLE
(13) Remove interlock cable from underside of
instrument panel.
INSTALLATION
CAUTION: When installing interlock cable assembly,
care must be taken not to bend exposed cable wire
and slug at shifter end of cable.
(1) Route interlock cable into lower dash panel and
towards console as removed.
(2) Turn the ignition switch to the ON/RUN posi-
tion (Fig. 283).
JR
Advertisement
Table of Contents
