Chrysler Sebring 2004 Service Manual page 1577

23 - 50 DOORS - REAR
TRIM PANEL (Continued)
INSTALLATION
(1) Position rear door trim panel on vehicle.
(2) Connect linkage to latch handle.
(3) Engage clip holding linkage to latch handle.
(4) Connect wiring harness at door opening.
(5) Position the lock knob through the trim panel
and engage trim panel from inner belt weatherstrip
at top of door.
(6) Align the clips attaching perimeter of trim
panel to rear door with the grommets and engage.
(7) Install screws attaching door trim panel to
door. (Fig. 9)
(8) Install screw holding door latch handle to door
and close the screw cap.
(9) Install screw from bottom of arm rest pull cup
and close the screw cap.
(10) Connect battery.
WINDOW REGULATOR
REMOVAL
(1) Remove door waterdam. (Refer to 23 - BODY/
DOORS - REAR/WATERDAM - REMOVAL)
(2) Remove glass from regulator roller channel.
Secure glass in the up position in the door frame.
(3) Disconnect power window motor wire connec-
tor, if equipped.
(4) Loosen screw attaching regulator scissor chan-
nel to door panel (Fig. 11).
(5) Remove screw and bolt heads from keyhole
slots in door panel.
(6) Loosen bolts attaching regulator to door panel.
(7) Remove regulator from door panel.
(8) Slide regulator rearward and rotate forward
end of roller channel through access hole in door
panel.
INSTALLATION
(1) Position regulator on door panel through access
hole in door panel.
(2) Tighten bolts attaching regulator to door panel.
Fig. 11 REAR DOOR REGULATOR
1 - REAR DOOR
2 - MOUNTING SLOTS
3 - REAGULATOR
4 - BOLTS
5 - BOLTS
6 - MOTOR
7 - ELECTRICAL CONNECTOR
8 - MOUNTING SLOTS
(3) Install screw and bolt heads on scissor channel
to keyhole slots in door panel.
(4) Tighten screw attaching regulator scissor chan-
nel to door panel.
(5) Connect power window motor wire connector, if
equipped.
(6) Position glass to regulator roller channel.
(7) Tighten fasteners attaching door glass to roller
channel.
(8) Install door waterdam. (Refer to 23 - BODY/
DOORS - REAR/WATERDAM - INSTALLATION)
JR