Chrysler Sebring 2004 Service Manual page 1321

21 - 60 T850 MANUAL TRANSAXLE
T850 MANUAL TRANSAXLE (Continued)
(7) Install a 1 mm (0.04 in.) bead of Mopar Gas-
ket Maker to differential cover and install to case.
Torque differential cover-to-case bolts to 54 N·m (40
ft. lbs.).
(8) Install a 1 mm (0.04 in.) bead of Mopar Gas-
ket Maker to bearing plate. Install bearing plate to
differential cover and case and torque bolts to 28
N·m (250 in. lbs.) (Fig. 36).
Fig. 36 Bearing Plate-to-Case Bolts
1 - PLATE
2 - BOLT (5)
(9) Verify proper differential turning torque.
(10) Install both axle output shaft seals using
driver handle C-4171 and installer 8476 (Fig. 37).
Fig. 37 Axle Seal Installation—Typical
1 - SEAL
2 - INSTALLER 8476
3 - DRIVER HANDLE C-4171
NOTE: If input shaft assembly was not disassem-
bled, it is necessary to remove input shaft sealed
ball bearing before assembling transaxle. (Refer to
21 - TRANSMISSION/TRANSAXLE/MANUAL/INPUT
SHAFT - DISASSEMBLY)
(11) Install assembled input and intermediate
shafts to fixture 8487 (Fig. 38).
Fig. 38 Install Geartrain to Fixture 8487
1 - INTERMEDIATE SHAFT
2 - INPUT SHAFT
2 - FIXTURE 8487
JR