Chrysler Sebring 2004 Service Manual page 1669

23 - 142 WEATHERSTRIP/SEALS
REAR DOOR INNER BELT
WEATHERSTRIP
REMOVAL
(1) Remove rear door trim panel. (Refer to 23 -
BODY/DOORS - REAR/TRIM PANEL - REMOVAL)
(2) Pull upward at front end of inner belt weather-
strip.
(3) Remove inner belt weatherstrip from vehicle
(Fig. 20).
Fig. 20 Rear Door Inner Belt Weatherstrip
1 - INNER BELT WEATHERSTRIP
INSTALLATION
(1) Place inner belt weatherstrip into position.
(2) Push downward on the inner belt weatherstrip.
(3) Install rear door trim panel. (Refer to 23 -
BODY/DOORS - REAR/TRIM PANEL - INSTALLA-
TION)
REAR DOOR OUTER BELT
MOLDING
REMOVAL
(1) Remove screw attaching forward end of mold-
ing to rear door (Fig. 21).
(2) Disengage clips attaching rearward end of belt
molding to rear door.
(3) Using a rubber mallet and block of wood, tap
upward at each clip attaching belt molding to door
(Fig. 22).
(4) Remove belt molding from door.
Fig. 21 Rear Door Outer Belt Molding
1 - OUTSIDE BELT MOLDING
2 - REAR DOOR
3 - BARREL CLIP
Fig. 22 Outer Belt Molding Removal
1 - WOOD BLOCK
2 - BELT MOLDING
3 - DOOR
INSTALLATION
(1) Place belt molding into position.
(2) Push or tap downward at each clip attaching
belt molding to door.
(3) Engage clips attaching rearward end of belt
molding to rear door.
(4) Install screw attaching forward end of molding
to rear door.
JR