Chrysler Sebring 2004 Service Manual page 1383

21 - 122 41TE AUTOMATIC TRANSAXLE
41TE AUTOMATIC TRANSAXLE (Continued)
(15) Measure input shaft end play. Place transaxle
so input shaft is vertical. Set up end play set and
dial indicator as shown in (Fig. 23). Input shaft end
play should be within 0.13-0.64 mm (0.005-0.025
in.) If outside of this range, a #4 thrust plate change
is required. Record indicator reading for reference
upon reassembly.
Fig. 23 Measure Input Shaft End Play Using End
Play Set 8266
1 - TOOL 8266–8
2 - TOOL 8266–2
3 - TOOL C-3339
(16) Remove oil pump-to-case bolts (Fig. 24).
Fig. 24 Remove Pump Attaching Bolts
1 - PUMP ATTACHING BOLTS
2 - PUMP HOUSING
CAUTION: Be sure input speed sensor is removed
before removing oil pump.
(17) Install pullers Tool C-3752 as shown in (Fig.
25).
Fig. 25 Install Tool C-3752
1 - PULLERS TOOL C-3752
2 - PUMP
(18) Remove oil pump assembly (Fig. 26) (Fig. 27).
Fig. 26 Remove Oil Pump
1 - "PUSH IN" ON INPUT SHAFT WHILE REMOVING PUMP
JR