Chrysler Sebring 2004 Service Manual page 1656

JR
SUNROOF HOUSING DRAIN HOSE (Continued)
Fig. 4 FRONT DRAIN HOSE
1 - FRONT DRAIN TUBE
2 - DRAIN TUBE GRUMMET
3 - COWL SIDE PANEL
4 - WINDSHIELD OPENING SIDE OUTER FRAME
REAR HOUSING HOSE
(1) Move glass panel to the fully closed position.
(2) Remove sunroof opening trim lace. (Refer to 23
- BODY/SUNROOF/OPENING
REMOVAL).
(3) Disconnect the control switch and wire connec-
tor.
(4) Remove headliner. (Refer to 23 - BODY/INTE-
RIOR/HEADLINER - REMOVAL).
(5) Disconnect the drain hose from the sunroof
housing (Fig. 5).
(6) Drain any liquid from hose connection, if nec-
essary.
(7) Attach new drain hose to old hose with tape
that is to be replaced.
(8) Work the old hose back and forth to loosen the
sealer.
(9) Pull the old hose out through the bottom and
the new hose through.
INSTALLATION
FRONT HOSES
(1) Connect the drain hose to the sunroof housing
and test drainage (Fig. 4).
(2) Set headliner into position.
(3) Connect express module, drive motor, and con-
trol switch wire connectors.
(4) Test sunroof operation, adjust as necessary.
(5) Finish installing headliner. (Refer to 23 -
BODY/INTERIOR/HEADLINER - INSTALLATION).
TRIM LACE -
BODY/SUNROOF/OPENING TRIM LACE - INSTAL-
LATION).
Install control switch.
Fig. 5 REAR DRAIN TUBE
1 - REAR DRAIN TUBE
2 - QUARTER INNER UPPER PANEL
3 - DRAIN TUBE GROMMET
4 - REAR DRAIN LOWER TUBE
(6) Install sunroof opening trim lace. (Refer to 23 -
(7) Connect the control switch wire connector.
SUNROOF 23 - 129