Chrysler Sebring 2004 Service Manual page 2041

DRIVEABILITY - GAS
P0340-NO CAM SIGNAL AT PCM —
TEST
6 Turn the ignition off.
Disconnect the CMP Sensor harness connector.
Turn the ignition on.
Measure the voltage of the (K44) CMP Sensor Signal circuit in the CMP Sensor
harness connector.
Is the voltage between 4.5 and 5.0 volts?
Yes → Go To 7
No
7 Turn the ignition off.
Disconnect the CMP Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance of the (K4) Sensor ground circuit between the CMP Sensor
harness connector and the PCM harness connector.
Is the resistance below 5.0 ohms?
Yes → Go To 8
No
8 NOTE: Inspect the Camshaft sprocket for damage per the Service Informa-
tion. If a problem is found repair as necessary.
If there are no possible causes remaining, view repair.
Repair
9 Turn the ignition off.
Disconnect the CMP Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance of the (K44) CMP Sensor Signal circuit in the CMP Sensor
harness connector to ground.
Is the resistance below 100 ohms?
Yes → Repair the short to ground in the (K44) CMP Sensor Signal
No
10 Turn the ignition off.
Disconnect the CMP Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance of the (K44) CMP Sensor Signal circuit between the CMP
Sensor harness connector and the PCM harness connector.
Is the resistance below 5.0 ohms?
Yes → Go To 11
No
ACTION
→ Go To 9
→ Repair the open in the (K4) Sensor ground circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
Replace the Camshaft Position Sensor.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
→ Go To 10
→ Repair the open in the (K44) CMP Sensor Signal circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
Continued
112
APPLICABILITY
All
All
All
All
All