Chrysler Sebring 2004 Service Manual page 1973

DRIVEABILITY - GAS
P0106-BAROMETRIC PRESSURE OUT OF RANGE —
TEST
8 Turn the ignition off.
Disconnect the MAP Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance of the (K6) 5-volt Supply circuit in the MAP Sensor harness
connector to ground.
Is the resistance below 100 ohms?
Yes → Repair the short to ground in the (K6) 5-volt Supply circuit.
No
9 NOTE: Before Continuing: Disconnect the PCM harness connector and
check the related wiring terminals for corrosion, damage or terminal push
out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and connectors. Pay
particular attention to all Power and Ground circuits.
If there are no possible causes remaining, view repair.
Repair
ACTION
Perform POWERTRAIN VERIFICATION TEST VER - 5.
→ Go To 9
Replace and program the Powertrain Control Module in accor-
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
44
Continued
APPLICABILITY
All
All