Chrysler Sebring 2004 Service Manual page 1333

21 - 72 T850 MANUAL TRANSAXLE
AXLE SEALS
REMOVAL
(1) Raise vehicle on hoist.
(2) Remove one or both front halfshaft assemblies.
(Refer to 3 - DIFFERENTIAL & DRIVELINE/HALF
SHAFT - REMOVAL)
(3) Using a suitable screwdriver, remove one or
both axle seals (Fig. 61).
Fig. 61 Axle Seal Removal (Bearing Plate Side)
1 - PLATE
2 - SEAL
3 - SCREWDRIVER
INSTALLATION
(1) Using driver handle C-4171 and installer 8476,
install axle seals into position (Fig. 62).
(2) Install one or both front halfshaft assemblies.
(Refer to 3 - DIFFERENTIAL & DRIVELINE/HALF
SHAFT - INSTALLATION)
(3) Check transaxle fluid level and adjust if neces-
sary. (Refer to 21 - TRANSMISSION/TRANSAXLE/
MANUAL/FLUID - STANDARD PROCEDURE)
(4) Lower vehicle.
BACK-UP LAMP SWITCH
REMOVAL
(1) Raise vehicle on hoist.
(2) Disconnect back-up lamp switch connector.
(3) Remove back-up lamp switch (Fig. 63).
Fig. 62 Axle Seal Installation
1 - SEAL
2 - INSTALLER 8476
3 - DRIVER HANDLE C-4171
Fig. 63 Back-Up Lamp Switch
1 - BACK-UP LAMP SWITCH
INSTALLATION
(1) Install back-up lamp switch (Fig. 63) and
torque to 23 N·m (17 ft. lbs.) using Tool 8827.
(2) Connect back-up lamp switch connector.
(3) Lower vehicle.
JR