23 - 140
WEATHERSTRIP/SEALS
HEADER WEATHERSTRIP
RETAINER/MOLING
REMOVAL
(1) Partially raise convertible top.
(2) Remove header and A-pillar weatherstrip as
necessary to gain access.
(3) Remove screws attaching A-pillar weatherstrip
retainer to header weatherstrip retainer.
(4) Remove screws attaching header weatherstrip
retainer to header panel (Fig. 15).
(5) Remove retainer from vehicle.
Fig. 15 Header Weatherstrip Retainer
1 - HEADER WEATHERSTRIP RETAINER
2 - HEADER
INSTALLATION
(1) Clean any residual seal material from header
panel.
(2) Position header weatherstrip retainer on vehi-
cle.
(3) Install screws attaching retainer to header
panel. Install center screw first and then work out-
ward.
(4) Install screws attaching A-pillar weatherstrip
retainer to header retainer.
(5) Install L foam in upper corner starting at
upper screw on the A-pillar retainer.
(6) Install L foam in upper corner starting at
upper screw on A-pillar.
(7) Install header and A-pillar weatherstrip.
(8) Lower and secure convertible top.
OUTER DOOR BELT
WEATHERSTRIP
REMOVAL
(1) Remove door glass.
(2) Remove screws attaching outer belt weather-
strip to outer door panel (Fig. 16).
(3) Remove outer belt weatherstrip from the vehi-
cle.
Fig. 16 Door Outer Belt Weatherstrip
1 - DOOR OUTER BELT WEATHERSTRIP
2 - OUTER DOOR PANEL
INSTALLATION
(1) Position outer belt weatherstrip on vehicle.
(2) Install screws to hold outer weatherstrip to
outer door panel.
(3) Install door glass.
QUARTER PANEL
WEATHERSTRIP
REMOVAL
(1) Remove door sill trim panel.
(2) Remove push in fasteners holding weatherstrip
to B-pillar.
(3) Remove weatherstrip from door opening flange.
(4) Remove quarter panel weatherstrip from vehi-
cle (Fig. 17).
Fig. 17 Quarter Panel Weatherstrip
1 - QUARTER PANEL WEATHERSTRIP
2 - QUARTER PANEL
3 - DOOR OPENING FLANGE
JR