Chrysler Sebring 2004 Service Manual page 2052

Symptom:
P0403 - EGR SOLENOID CIRCUIT
When Monitored and Set Condition:
P0403 - EGR SOLENOID CIRCUIT (2.7L)
When Monitored: Engine running. Battery voltage greater than 10 volts.
Set Condition: The EGR solenoid control circuit is not in the expected state when
requested to operate by the PCM.
GOOD TRIP EQUAL TO ZERO
(F142) ASD RELAY OUTPUT CIRCUIT OPEN
EGR SOLENOID ASSEMBLY
(K35) EGR SOLENOID CONTROL CIRCUIT SHORTED TO VOLTAGE
(K35) EGR SOLENOID CONTROL CIRCUIT SHORTED TO GROUND
(K35) EGR SOLENOID CONTROL CIRCUIT SHORTED TO (K4) SENSOR GROUND CIRCUIT
(K35) EGR SOLENOID CONTROL CIRCUIT OPEN
PCM
TEST
1 Turn the ignition on.
With the DRBIII , read DTC's.
Is the Good Trip displayed and equal to zero?
Yes → Go To 2
→ Refer to the INTERMITTENT CONDITION symptom in the
No
2 Turn the ignition off.
Disconnect the EGR Solenoid harness connector.
Turn the ignition on.
With the DRB, actuate the ASD Relay.
Using a 12-volt Test Light connected to ground, probe the (F142) ASD Relay Output
circuit in the EGR Solenoid harness connector.
Does the 12-volt test light illuminate?
Yes → Go To 3
→ Repair the open in the (F142) ASD Relay Output circuit.
No
POSSIBLE CAUSES
ACTION
Driveability category.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
DRIVEABILITY - GAS
123
APPLICABILITY
All
All