Camshaft Inspection - Suzuki Wagon R Manual

6A4-48 ENGINE MECHANICAL (Z10XEP AND Z12XEP ENGINES)
Installation
1) Apply engine oil around hydraulic valve lash adjuster (1) and
valve rocker arm (2), and install them to cylinder head.
2) Install intake and/or exhaust camshaft(s) as follows.
a) Coat sliding surfaces of camshaft and camshaft housing
with sliding paste.
Grease: MoS2 sliding paste (grey) 99000-84E00
b) Install camshaft.
c) Install camshaft housing to original position.
d) Tighten camshaft housing bolts in such order as indicated
in the figure a little at a time till they are tightened to speci-
fied torque.
Tightening torque
Camshaft housing bolt
(a): Tighten 8 N·m (0.8 kg-m, 6.0 lb-ft) by the specified pro-
cedure
3) Insert special tool.
Special tool
09919-58310
4) Install timing chain referring to "Timing Chain and Chain Ten-
sioner Removal and Installation" in this section.
5) Install timing chain cover referring to "Timing Chain Cover
Removal and Installation" in this section.
6) Install cylinder head cover referring to "Cylinder Head Cover
Removal and Installation" in this section.
7) Install oil pan referring to "Oil Pan and Oil Pump Strainer and
Oil Baffle Plate Removal and Installation" in this section.
8) Install engine assembly to engine compartment referring to
"Engine Assembly Removal and Installation" in this section.

Camshaft Inspection

CAUTION:
• When camshaft is faulty, each valve rocker arm and
hydraulic valve lash adjuster must be replaced.
• When camshaft housing is faulty, cylinder head must
be replaced.
Check camshafts, camshaft bearing cap, hydraulic valve lash
adjuster and valve rocker arm and cylinder block for wear or dam-
age.
If any malcondition is found replace camshafts, camshaft bearing
caps, hydraulic valve lash adjuster, valve rocker arm or cylinder
block.