Suzuki Wagon R Manual page 3887

6A4-60 ENGINE MECHANICAL (Z10XEP AND Z12XEP ENGINES)
2) When installing piston and connecting rod assembly into cyl-
inder bore, point arrow mark (1) on piston head to crankshaft
pulley side (2).
3) Install piston and connecting rod assembly into cylinder bore
matching cylinder number marked in removal. Use special
tool (piston ring compressor) to compress rings. Guide con-
necting rod into place on crankshaft.
Using a hammer handle, tap piston head to install piston into
bore. Hold ring compressor firmly against cylinder block until
all piston rings have entered cylinder bore.
Special tool
(A): 09916-77310
4) Install bearing cap (1) with pointing mark (2) on cap to fly-
wheel side. And tighten connecting bearing cap bolts as fol-
lows.
a) Tighten all connecting rod bearing cap bolts (3) to 13 N·m
(1.3 kg-m, 9.5 lb-ft).
b) Retighten them by turning through 60°.
c) Retighten them by turning through 15°.
Tightening torque
Connecting rod bearing cap bolt
(a): Tighten 13 N·m (1.3 kg-m, 9.5 lb-ft), 60° and 15° by the
specified procedure
5) Insert special tool to closure bolt hole until flange of special
tool contact with cylinder block.
Special tool
(A): 09912-38310
6) Install cylinder head referring to "Valves and Cylinder Head
Assembly Removal and Installation" in this section.
7) Install intake and exhaust camshaft assembly referring to
"Camshaft Assembly Removal and Installation" in this sec-
tion.
8) Install timing chain referring to "Timing Chain and Chain Ten-
sioner Removal and Installation" in this section.