Suzuki Wagon R Manual page 3652

WARNING:
Do not removal all of the wheel bolts at once, because all the wheels of this vehicle are mounted by
the wheel bolts.
Leave a bolt at least not to drop the wheel.
Support the wheel and/or tire and then remove the bolt(s) left with the wheel.
NOTE:
• All suspension fasteners are an important attaching part in that it could affect the performance of
vital parts and systems, and/or could result in major repair expense. They must be replaced with
one of the same part number or with an equivalent part if replacement becomes necessary. Do not
use a replacement part of lesser quality or substitute design. Torque values must be used as speci-
fied during reassembly to assure proper retention of this part.
•
Never attempt to heat, quench or straighten any suspension part. Replace it with a new part, or damage
.
to the part may result
• Refer to the same section of the Service Manual mentioned in the FOREWORD of this manual for all
of this section except the following.
– Tighten wheel bolt to 110 N·m (11.0 kg-m, 79.5 lb-ft) instead of 95 N·m (9.5 kg-m, 69.0 lb-ft) which
is instructed in the same section of the Service Manual mentioned in "FOREWORD" of this man-
ual.
– Tighten lateral rod nut (body side) to 90 N·m (9.0 kg-m, 65.0 lb-ft) instead of 100 N·m (10.0 kg-m,
72.5 lb-ft) which is instructed in the same section of the Service Manual mensioned in "FORE-
WORD" of this manual.
Tightening torque
Wheel bolt: 110 N·m (11.0 kg-m, 79.5 lb-ft)
Lateral rod nut (body side): 90 N·m (9.0 kg-m,
65.0 lb-ft)
SECTION 3E
REAR SUSPENSION
REAR SUSPENSION 3E-1
3E
3F
4
4B
5
5A
5B
5C
6-2
6A2
6B2