Suzuki Wagon R Manual page 3752

Test
T09 Check: Component
• Remove fused jumper wire
• Connect fused jumper wire to:
TP sensor - Wiring harness connector (wiring harness side) termi-
nal C25-2
&
TP sensor - Wiring harness connector (wiring harness side) termi-
nal C25-5
• Scan Tool Data List Parameter
TP Sensor 2 Volt
Yes: T10
T10 Check: Short to Voltage of Voltage Supply Circuit
• Ignition OFF
• Disconnect wiring harness connector from:
ECM (Wiring Harness Connector C36)
• Ignition ON
• Measure voltage between the following terminals:
TP sensor - Wiring harness connector (wiring harness side) termi-
nal C25-1
&
Ground
Yes: T11
T11 Check: Short to Voltage of Voltage Supply Circuit
• Measure voltage between the following terminals:
TP sensor - Wiring harness connector (wiring harness side) termi-
nal C25-4
&
Ground
Yes: T12
T12 Check: Short to Ground of Voltage Supply Circuit
• Ignition OFF
• Measure resistance between the following terminals:
TP sensor - Wiring harness connector (wiring harness side) termi-
nal C25-4
&
Ground
Yes: T13
T13 Check: Interruption of Voltage Supply Circuit
• Measure resistance between the following terminals:
ECM - Wiring harness connector (wiring harness side) terminal
C36-14
&
TP sensor - Wiring harness connector (wiring harness side) termi-
nal C25-4
Yes: T14
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES) 6-4-71
Work Order Description Nominal Value
less than 0.3 V
No: E08
less than 0.3 V
No: E07
less than 0.3 V
No: E06
greater than 500 kΩ
No: E05
less than 5 Ω
No: E04