Suzuki Wagon R Manual page 3810

Test
T07 Check: Interruption of Voltage Supply Circuit
• Ignition OFF
• Remove test light
• Connect fused jumper wire to:
A/C compressor relay - Socket terminal E62-2-4 (Z10XEP) or E55-
3 (Z12XEP)
&
Battery voltage
• Clicking noise from following component:
Magnet clutch
Yes: E01
T08 Check: Circuit Interruption of Ground Circuit
• Disconnect wiring harness connector from:
Magnet clutch
• Measure voltage between the following terminals:
Magnet clutch - Wiring harness connector (wiring harness side)
terminal E62-2-4 (Z10XEP) or E55-3 (Z12XEP)
&
Ground
Yes: E02
T09 Check: Short to Ground/Interruption of Voltage Supply Circuit
• Ignition OFF
• Remove electrical component from socket:
Circuit fuse
• Check the following component for proper operation:
Circuit fuse
Yes: T10
T10 Check: Interruption of Voltage Supply Circuit
• Measure voltage between the following terminals:
Circuit fuse - Input contact
&
Ground
Yes: E07
T11 Check: Short to Ground/Interruption of Voltage Supply Circuit
• Remove electrical component from socket:
Circuit fuse
• Check the following component for proper operation:
Circuit fuse
Yes: E11
T12 Check: Short to Ground of Voltage Supply Circuit
• Connect fused jumper wire to: A/C compressor relay - Socket ter-
minal E62-2-4 (Z10XEP) or E55-3 (Z12XEP)
&
Battery voltage
• Check the following component for proper operation:
Fuse of the fused jumper wire
Yes: E12
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES) 6-4-129
Work Order Description Nominal Value
Test OK?
No: T08
greater than 11 V
No: E03
Test OK?
No: E09
greater than 11 V
No: E08
Test OK?
No: T12
Test OK?
No: E13