Suzuki Wagon R Manual page 3734

Test
T05 Check: Interruption of Signal Circuit
• Measure resistance between the following terminals:
ECM - Wiring harness connector (wiring harness side) terminal
C36-27
&
ECM - Wiring harness connector (wiring harness side) terminal
C36-43
Yes: E03
Result Table
Result
E01 • Defective component:
ECM
NOTE:
If ECM is replaced, register password (PWD) and secret key code (SKC) to ECM referring to
"Procedure after ECM Replacement" in Section 8G3.
E02 • Defective component:
CKP sensor
(intermittent problems, missing teeth, wrong reference point, incorrect gap position, etc.)
E03 • Short circuit in wiring harness between:
ECM - Wiring harness connector (wiring harness side) terminal C36-27
&
ECM - Wiring harness connector (wiring harness side) terminal C36-43
or
• Defective component:
CKP sensor
E04 • Circuit interruption between:
ECM - Wiring harness connector (wiring harness side) terminal C36-27
&
CKP sensor - Wiring harness connector (wiring harness side) terminal C16-2
or
ECM - Wiring harness connector (wiring harness side) terminal C36-43
&
CKP sensor - Wiring harness connector (wiring harness side) terminal C16-1
or
• Defective component:
CKP sensor
E05 • Short circuit to ground between:
ECM - Wiring harness connector (wiring harness side) terminal C36-43
&
CKP sensor - Wiring harness connector (wiring harness side) terminal C16-1
or
ECM - Wiring harness connector (wiring harness side) terminal C36-27
&
CKP sensor - Wiring harness connector (wiring harness side) terminal C16-2
or
• Defective component:
CKP sensor
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES) 6-4-53
Work Order Description
Cause Of Fault
Nominal Value
less than 600 Ω
No: E04