Suzuki Wagon R Manual page 3897

6A4-70 ENGINE MECHANICAL (Z10XEP AND Z12XEP ENGINES)
5) Install lower crankcase as follows.
a) Apply sealant to cylinder block (outer edge) as shown in fig-
ure.
"A": xxxxxxxxxxx
CAUTION:
Complete installation of lower crankcase within 10 min-
utes after applying sealant.
Do not apply sealant to inside of groove.
b) Install lower crankcase to cylinder block.
c) Tighten crankcase bolts (M8) to 25 N·m (2.5 kg-m, 18.0 lb-
ft).
NOTE:
Tighten crankcase bolts gradually in symmetrical order
starting from the center outward until they are tightened
to specified torque.
d) Retighten by turning crankcase bolts (M8) to 60°.
e) Tighten crankcase bolts (M6) to 10 N·m (1.0 kg-m, 7.5 lb-
ft).
f) Retighten by turning crankcase bolts (M6) to 60°.
NOTE:
After tightening lower crankcase bolts, check to be sure
that crankshaft rotates smoothly.
Tightening torque
Crankcase bolt (M8)
(a): Tighten 25 N·m (2.5 kg-m, 18.0 lb-ft) and 60° by the
specified procedure
Crankcase bolt (M6)
(b): Tighten 10 N·m (1.0 kg-m, 7.5 lb-ft) and 60° by the
specified procedure
"a": 2.0 mm (0.078 in.)
g) Remove surplus sealant.
6) Install crankshaft rear oil seal (1) as follows.
a) Coat seal lip grease.
MOS2 sliding paste (grey) 99000-84E00
b) Attach "KM-235-6" included in special tool (A) to crankshaft.
c) Push seal ring onto special tool (A).
d) Hammer in flush with special tool (B).
Special tool
(A): 09911-98310
(B): 09911-98320
e) Remove special tool (A) and (B).