Suzuki Wagon R Manual page 3608

[A]
SAE 0W-30, 0W-40
SAE 5W-30, 5W-40
C -30 -20 -10 0 10 20
F -22 -4 14 32 50 68
2 1
5) Replenish oil until oil level is brought to FULL level mark on
dipstick. (for Z10XEP engine about 3.0 liters (5.3 lmp pt.), for
Z12XEP engine about 3.5 liters (6.2 lmp pt.)) The filler inlet is
by the engine oil filter.
Use specified engine oil. Select the appropriate oil viscosity
according to the proper engine oil viscosity chart [A].
NOTE:
30 40
86 104
Note that the amount of oil required when actually chang-
ing oil may somewhat differ from the data depending on
various conditions (temperature, viscosity, etc.)
6) Check oil filter and drain plug for oil leakage.
7) Start engine and run it for 3 minutes. Stop it and wait 5 min-
utes before checking oil level. Add oil, as necessary, to bring
oil level to FULL level mark on dipstick.
1. Full level mark
2. Low level mark
Engine Coolant Replacement
WARNING:
To help avoid danger of being burned, do not remove
radiator cap while engine and radiator are still hot. Scald-
ing fluid and steam can be blown out under pressure if
cap is taken off too soon.
Change engine coolant with new one referring to "Cooling System
Flush and Refill" in Section 6B4 (Z10XEP / Z12XEP engines) or
6B3 (Z13DT engine).
Spark Plugs Replacement
Replace spark plugs with new ones referring to "Spark Plugs
Removal and Installation" in Section 6F4.
Air Cleaner Filter Inspection (Z10XEP /
Z12XEP Engines)
Check air cleaner filter for dirt and damage, and clean if neces-
sary referring to "Air Cleaner Element Inspection and Cleaning" in
Section 6A4.
MAINTENANCE AND LUBRICATION 0B-9