Suzuki Wagon R Manual page 3742

Test
T11 Check: Short to Voltage/Ground/Interruption of Voltage Supply
• Measure voltage between the following terminals:
Accelerator pedal position sensor - Wiring harness connector (wir-
ing harness side) terminal G82-5
&
Ground
Yes: T12
T12 Check: Short to Voltage of Signal Circuit
• Ignition OFF
• Disconnect wiring harness connector from:
ECM (Wiring Harness Connector G21)
• Ignition ON
• Measure voltage between the following terminals:
Accelerator pedal position sensor - Wiring harness connector (wir-
ing harness side) terminal G82-5
Ground
Yes: E10
T13 Check: Short to Ground of Signal Circuit
• Ignition OFF
• Disconnect wiring harness connector from:
ECM (Wiring Harness Connector G21)
• Measure resistance between the following terminals:
Accelerator pedal position sensor - Wiring harness connector (wir-
ing harness side) terminal G82-5
&
Ground
Yes: T14
T14 Check: Short to Ground/Interruption of Signal Circuit
• Measure resistance between the following terminals:
Accelerator pedal position sensor - Wiring harness connector (wir-
ing harness side) terminal G82-5
&
ECM - Wiring harness connector (wiring harness side) terminal
G21-21
Yes: E10
T15 Check: Short to Voltage/Ground/Interruption of Voltage Supply
• Ignition OFF
• All consumers turned off
• Disconnect wiring harness connector from:
Accelerator pedal position sensor
• Ignition ON
• Measure voltage between the following terminals:
Accelerator pedal position sensor - Wiring harness connector (wir-
ing harness side) terminal G82-6
&
Ground
Yes: T16
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES) 6-4-61
Work Order Description Nominal Value
greater than 5.2 V
No: T13
less than 0.3 V
No: E11
greater than 500 kΩ
No: E13
less than 5 Ω
No: E12
greater than 5.2 V
No: T24