Suzuki Wagon R Manual page 3643

1B-24 AIR CONDITIONING (OPTIONAL)
Installation
Z10XEP and Z12XEP Engine Models
Reverse removal procedure to install compressor noting the fol-
lowing instructions.
• If compressor is replaced, pour new compressor oil by refer-
ring to "Replenishing Compressor Oil" under "Compressor"
in this section.
• Evacuate and charge system by referring to "Operation Pro-
cedure for Charging A/C with Refrigerant" in this section.
Tightening torque
Suction and discharge hoses bolt
(a): 25 N·m (2.5 kg-m, 18.0 lb-ft)
Compressor mounting bolt
(b): 20 N·m (2.0 kg-m, 14.5 lb-ft)
Z13DT Engine Model
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
Magnet Clutch
Inspection
Z10XEP and Z12XEP Engine Models
• Check armature plate and magnet clutch pulley for wear and
oil soaked conditions respectively.
• Check magnet clutch pulley bearing for noise, wear and
grease leakage.
• Measure magnet clutch coil for resistance at 20
If the measured resistance does not remain within above tol-
erance, replace compressor assembly.
Standard Resistance: approximately 3.7 Ω
Z13DT Engine Model
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
° °
C (68 F).