Suzuki Wagon R Manual page 3691

6-4-10 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES)
Test
T06 Diagnostic Trouble Codes
NOTE:
Trouble codes are only a reference on faults in a subgroup of the
system. Trouble codes are not a direct reference on a defective
component.
• Read and record diagnostic trouble codes
• Delete trouble codes
• Operate the vehicle over an appropriate distance at various engine
speed/load conditions
• If a trouble code is stored:
Refer to Table B-01 Diagnostic Trouble Code
• After successful test/fault repair proceed to the next test step
Yes: T07
T07 Check: Symptom/Customer Complaint
If a defect has been found in previous test steps, the following test
can be skipped (follow result "YES").
• Evaluate customer complaint:
Refer to Table B-04 Symptom Chart/Customer Complaints
• After successful test/fault repair proceed to the next test step
Yes: T08
T08 No Matching Customer Complaint
If a defect has been found in previous test steps, the following test
can be skipped (follow result "YES").
• Perform the following evaluation:
Refer to Table B-07 No Matching Customer Complaint
• After successful test/fault repair proceed to the next test step
Yes: T09
T09 System/Function End Test
• Check if the customer complaint is repaired and the concerned
system is fully operational.
NOTE:
Drive the vehicle in different driving conditions (engine speed
and engine load conditions) over a considerable distance. Pay
attention to unusual noise and other system irregularities.
• Turn ignition OFF and ON
• Delete trouble codes
NOTE:
Read the trouble codes again after the test drive and check for
symptoms/customer complaints. If a complaint still exists,
restart the diagnostic session for a second time.
Yes: –
Work Order Description Nominal Value
NO: –
NO: –
NO: –
NO: –