Suzuki Wagon R Manual page 3694

B-02: Data List
Depending on the vehicle/system configuration it is possible that some data list parameters or test steps,
although they are listed in this checking procedure, are not shown on the diagnostic tester display. In that case,
these data list parameters are not valid for this vehicle/system configuration.
Test
T01 Tester Display – Battery Voltage
• Ignition ON
• Engine OFF
• All consumers turned off
• Engine starting
• Engine running
• All consumers turned off
Concerned Terminals:
G21-19, G21-33, G21-49
Yes: T02
T02 Tester Display – Main Relay
• Ignition ON
• Engine OFF
• All consumers turned off
Concerned Terminals:
G21-19, G21-33, G21-49
Yes: T03
T03 Tester Display – Fuel Pump
• Ignition ON
• Engine OFF
• All consumers turned off
• Engine running at idle speed, operating temperature
• Accelerator pedal not actuated
Concerned Terminals:
G21-62
Yes: T04
T04 Tester Display – APP Sensor 1 Volt (Accelerator Pedal Position Sen-
sor 1 Voltage)
• Ignition ON
• Engine OFF
• All consumers turned off
• Accelerator pedal not actuated
• Accelerator pedal slightly actuated
• Accelerator pedal actuated to full load stop
Concerned Terminals:
G21-4, G21-5, G21-21, G21-22, G21-37, G21-54
Yes: T05
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES) 6-4-13
Work Order Description Nominal Value
11 – 13.5 V
greater than 8 V
12 – 15 V
No: C-03
Active
No: C-03
Inactive
Active
No: C-05
less than 1.2 V
greater than 3.0 V
No: C-06