Suzuki Wagon R Manual page 3753

6-4-72 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES)
Test
T14 Check: Short to Ground of Voltage Supply Circuit
• Measure resistance between the following terminals:
TP sensor - Wiring harness connector (wiring harness side) termi-
nal C25-1
&
Ground
Yes: T15
T15 Check: Interruption of Voltage Supply Circuit
• Measure resistance between the following terminals:
ECM - Wiring harness connector (wiring harness side) terminal
C36-30
&
TP sensor - Wiring harness connector (wiring harness side) termi-
nal C25-1
Yes: E01
Result Table
Result
E01 • Defective component:
ECM
or
TP sensor
NOTE:
If ECM is replaced, register password (PWD) and secret key code (SKC) to ECM referring to
"Procedure after ECM Replacement" in Section 8G3.
E02 • Circuit interruption between:
ECM - Wiring harness connector (wiring harness side) terminal C36-30
&
TP sensor - Wiring harness connector (wiring harness side) terminal C25-1
E03 • Short circuit to ground between:
ECM - Wiring harness connector (wiring harness side) terminal C36-30
&
TP sensor - Wiring harness connector (wiring harness side) terminal C25-1
E04 • Circuit interruption between:
ECM - Wiring harness connector (wiring harness side) terminal C36-14
&
TP sensor - Wiring harness connector (wiring harness side) terminal C25-4
E05 • Short circuit to ground between:
ECM - Wiring harness connector (wiring harness side) terminal C36-14
&
TP sensor - Wiring harness connector (wiring harness side) terminal C25-4
E06 • Short circuit to voltage between:
ECM - Wiring harness connector (wiring harness side) terminal C36-14
&
TP sensor - Wiring harness connector (wiring harness side) terminal C25-4
E07 • Short circuit to voltage between:
ECM - Wiring harness connector (wiring harness side) terminal C36-30
&
TP sensor - Wiring harness connector (wiring harness side) terminal C25-1
Work Order Description
Cause Of Fault
Nominal Value
greater than 500 kΩ
No: E03
less than 5 Ω
No: E02