Suzuki Wagon R Manual page 3631

1B-12 AIR CONDITIONING (OPTIONAL)
A/C Condenser Assembly
CAUTION:
Be careful not to damage condenser fins. If condenser fin
is bent, straighten it by using flat head screwdriver or
pair of pliers.
Removal
Z10XEP and Z12XEP Engine Models
1) Disconnect negative (–) cable at battery.
2) Recover refrigerant from refrigeration system by using
recovery and recycling equipment.
3) Remove front bumper referring to "Front Bumper and Rear
Bumper" in Section 9.
4) Loosen discharge hose bolt (1) and liquid pipe bolt (2).
5) Loosen condenser mount bolt (3).
6) Remove condenser assembly (4).
Z13DT Engine Model
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
Installation
Z10XEP and Z12XEP Engine Models
Reverse removal sequence to install condenser, noting the follow-
ing point.
• If replace condenser, pour 15 cc of refrigerating oil to com-
pressor suction-side.
• Evacuate and charge system referring to "Operation Proce-
dure for Charging A/C with Refrigerant" in this section.
Tightening torque
Suction hose bolt (a): 10 N·m (1.0 kg-m, 7.5 lb-ft)
Discharge hose bolt (b): 10 N·m (1.0 kg-m, 7.5 lb-ft)
Condenser mount bolt (c): 5.5 N·m (0.55 kg-m, 4 lb-ft)
Z13DT Engine Model
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.