Suzuki Wagon R Manual page 3650

WARNING:
Do not removal all of the wheel bolts at once, because all the wheels of this vehicle are mounted by
the wheel bolts.
Leave a bolt at least not to drop the wheel.
Support the wheel and/or tire and then remove the bolt(s) left with the wheel.
NOTE:
• All front suspension fasteners are an important attaching part in that it could affect the performance
of vital parts and systems, and/or could result in major repair expense. They must be replaced with
one of the same part number or with an equivalent part if replacement becomes necessary. Do not
use a replacement part of lesser quality or substitute design. Torque values must be used as speci-
fied during reassembly to assure proper retention of this part.
• Never attempt to heat, quench or straighten any front suspension part. Replace it with a new part or
damage to the part may result.
• Refer to the same section of the Service Manual mensioned in the FOREWORD of this manual for all
of this section except the following.
– Tighten wheel bolt to 110 N·m (11.0 kg-m, 79.5 lb-ft) instead of 95 N·m (9.5 kg-m, 69.0 lb-ft) which
is instructed in the same section of the Service Manual mentioned in "FOREWORD" of this man-
ual.
Tightening torque
Wheel bolt: 110 N·m (11.0 kg-m, 79.5 lb-ft)
SECTION 3D
FRONT SUSPENSION
FRONT SUSPENSION 3D-1
3D