Suzuki Wagon R Manual page 3833

6A4-6 ENGINE MECHANICAL (Z10XEP AND Z12XEP ENGINES)
6) Start engine, and warm it up to normal operating tempera-
ture.
NOTE:
Be sure to place transaxle gear shift lever in "Neutral",
and set parking brake and block drive wheels.
7) After warming up, measure oil pressure at idle speed (750 –
950 rpm).
Oil pressure specification
Approx. 150 kPa (1.5 kg/cm
8) Stop engine, and remove oil pressure gauge and attach-
ment.
9) Install oil pressure switch (1), and connect oil pressure con-
nector.
Tightening torque
Oil pressure switch (a): 20 N·m (2.0 kg-m, 14.5 lb-ft)
10) Start engine, and check oil pressure switch (1) for oil leak-
age. If oil leakage is found, repair it.
11) Attach cover plate.
12) Install horn and connect horn connector.
1, (a)
13) Install front bumper referring to "Front Bumper and Rear
Bumper" in Section 9.
Timing Check
1) Disconnect negative cable at battery.
2) Remove air cleaner housing referring to "Air Cleaner Assem-
bly Removal and Installation" in Section 6A4.
3) Remove cylinder head cover referring to "Cylinder Head
Cover Removal and Installation" in Section 6A4.
4) Remove spark plugs.
5) Hoist vehicle.
6) Remove accessory drive belt cover (1).
2
, 21.3 psi) at idle speed