Suzuki Wagon R Manual page 3671

4A5-12 FRONT DRIVE SHAFT (Z12XEP ENGINE MODEL)
1
2
4) Set new differential side boot small band (2) and differential
side boot (1) on shaft temporarily.
5) Apply grease in the supplied parts to DOJ and inside of
housing.
Grease color: brown
Grease amount: Approx. 120 g (4.23 oz)
6) Place DOJ onto spline of drive shaft and drive onto drive
shaft by using plastic hammer until retaining ring engages.
7) Fit boot to grooves of shaft and housing and adjust length "a"
to specification below. Insert screwdriver into boot and allow
air to enter boot so that air pressure in boot becomes the
same as atmospheric pressure.
Length "a": Approximately 74.5 mm (2.93 in.)
CAUTION:
• To prevent any problem caused by washing solution,
do not wash boot. Degreasing of those parts with cloth
is allowed.
• Do not squeeze or distort boot when fastening it with
bands. Distorted boot caused by squeezing air may
reduce its durability.
[A]: Differential side
8) Install and fasten new boot big and small bands at that posi-
tion of step 7) in the same procedure as steps 6) to 9) of Tri-
pod Joint Type Drive Shaft Assembly.