Suzuki Wagon R Manual page 3630

NOTE:
When refrigerant line must be disconnected and connected to remove and reinstall any component of
A/C system, be sure to observe the following instructions.
• When disconnecting any line from the system, install a blinding plug or cap to fitting of such line
immediately.
• When connecting hoses and pipes to each other respectively, previously apply a few drops of com-
pressor oil (refrigerating oil) to O-ring.
• Do not reuse of O-ring.
Z10XEP and Z12XEP Engine Models
1. Suction hose
2. Discharge hose
Z13DT Engine Model
Refer to the same section of the Service Manual mentioned in the "FOREWORD" of this service manual.
Procedure after ECM Replacement
Z13DT Engine Model
Refer to the same section of the Service Manual mentioned in the "FOREWORD" of this service manual.
On-Vehicle Service
3. Liquid pipe
4. Expansion valve
AIR CONDITIONING (OPTIONAL) 1B-11
5. Receiver / Dryer
Apply compressor oil (refrigerant oil) to O-ring.