Suzuki Wagon R Manual page 3629

1B-10 AIR CONDITIONING (OPTIONAL)
Z13DT Engine Model
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
When charging refrigerant only
Z10XEP and Z12XEP Engine Models
When evacuating and charging refrigerant without replacing any
component part, replenish the same amount of measured oil
when recovering refrigerant (if not measured, replenish 30 cc oil).
Z13DT Engine Model
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
When replacing compressor
Z10XEP and Z12XEP Engine Models
CAUTION:
Be sure to use P/N: 99000-990C5-00A compressor oil or
an equivalent compressor oil.
Compressor oil is sealed in each new compressor by the amount
required for A/C system. Therefore, when using a new compres-
sor for replacement, drain oil from it by the amount calculated as
follows.
"C" = "A" – "B"
"C": Amount of oil to be drained
"A": Amount of oil sealed in a new compressor
"B": Amount of oil remaining in removed compressor
NOTE:
Compressor assembly supplied from factory is filled up
with the following amount of oil.
Oil amount in compressor
3
150 cm
(150 cc, 9.2 in
1. New compressor
2. Removed compressor
3. Compressor oil drain bolt
Tightening torque
Compressor oil drain bolt (a): 18 N·m (1.8 kg-m, 13.0 lb-ft)
Z13DT Engine Model
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
3
)