Suzuki Wagon R Manual page 3712

Test
T14 Tester Display – Service Vehicle Soon (SVS)
• Ignition ON
• Engine OFF
• Press corresponding key in the system main menu to select Out-
put Test under Misc Test, select the desired test and confirm with
ENTER. Follow the instructions in the scan tool display.
• After the test is started, the corresponding component can be actu-
ated using the YES/NO keys.
• Press NO key OFF
• Press YES key ON
NOTE:
The test is completed after a maximum of 30 sec.
Concerned Terminals:
G21-3
Yes: –
B-13: Additional Functions
Test
T01 Tester Display – Read ECM Identification
• Ignition ON
• Engine OFF
• Press corresponding key in the system main menu to Select under
Misc Test, select the desired test and confirm with ENTER. Follow
the instructions in the Scan Tool display.
NOTE:
This test can be used to monitor various different system spe-
cific data.
Yes: T02
T02 Tester Display – Display Immobilizer Status
Check immobilizer control system status referring to "Scan Tool Data"
in Section 8G3.
Yes: –
B-14: Programming
Test
T01 Tester Display – Reset O2-Loop Block Learned Map
• Ignition ON
• Press corresponding key in the system main menu to select ECM
Setting under Misc Test, select the desired test and confirm with
ENTER. Follow the instructions in the scan tool display.
NOTE:
This test can be used to monitor various different system spe-
cific data.
Yes: T02
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES) 6-4-31
Work Order Description
Work Order Description
Work Order Description
Nominal Value
System telltale OFF
System telltale ON
No: C-36
Nominal Value
Displayed value OK?
No: C-02
No: C-02
Nominal Value
Programming OK?
No: C-02