Suzuki Wagon R Manual page 3632

Inspection
Z10XEP and Z12XEP Engine Models
Check the following.
• Condenser fins for leakage, blockage and damage
• Condenser fittings for leakage
Clogged condenser fins should be washed with water, and should
be dried with compressed air.
NOTE:
Be careful not to damage condenser fins. If condenser fin
is bent, straighten it by using a screwdriver or pair of pli-
ers. If any leakage is found from fitting or tube, repair or
replace condenser.
Z13DT Engine Model
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
Receiver / Dryer
Removal
Z10XEP and Z12XEP Engine Models
1) Recover refrigerant from refrigeration system by using
recovery and recycling equipment.
NOTE:
The amount of removed compressor oil must be mea-
sured for replenishing compressor oil.
2) Remove A/C condenser assembly referring to A/C con-
denser assembly in this section.
3) Loosen receiver / dryer attachment bolt (1), (2).
4) Remove receiver / dryer (3).
Z13DT Engine Model
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
AIR CONDITIONING (OPTIONAL) 1B-13