Suzuki Wagon R Manual page 3915

6B4-8 ENGINE COOLING (Z10XEP AND Z12XEP ENGINES)
WARNING:
• Check to make sure that engine coolant temperature is cold before removing any part of cooling
system.
• Also be sure to disconnect negative cable from battery terminal before removing any part.
Cooling System Component
[A]: Forward
1. Radiator assembly
2. Hose clip
Be sure to position clip in specified direction as shown in figure.
3. Radiator cooling fan assembly
4. Radiator inlet hose
Be sure to connect hose aligning hose mark with stopper.
5. Radiator outlet hose
Be sure to connect hose aligning hose mark with stopper.
6. Radiator to degassing tank hose
7. Degassing tank cap
8. Degassing tank
9. Radiator outlet hose
10. Upper coolant pipe
11. Lower coolant pipe
On-Vehicle Service
12. Throttle body to degassing tank hose
13. Preheater hose
14. Thermostat
15. To throttle body
16. Heater outlet hose
17. Heater inlet hose
18. To water pump
19. To heater
20. Thermostat bolt
21. O-ring
22. Thermostat housing bolt
23. Coolant pipe bolt
24. Lower coolant pipe bolt
25. Upper radiator bracket bolt
26. Lower radiator bracket bolt
27. To cylinder block
8 N·m (0.8 kg-m, 6.0 lb-ft)
12 N·m (1.2 kg-m, 9.0 lb-ft)
20 N·m (2.0 kg-m, 14.5 lb-ft)
25 N·m (2.5 kg-m, 18.0 lb-ft)
10 N·m (1.0 kg-m, 7.5 lb-ft)
Do not reuse.