Polycom SoundStructure C16 Design Manual page 90

To add a new virtual channel group:
» Enter a group name in the Group Label: field and click Add Group, as shown in the following figures.
This figure shows an example of creating the Zone 1 Mics virtual channel group.
After you define a virtual channel group, you can add virtual channels to the virtual channel group by
selecting the desired virtual channels. You can select more than one virtual channel by left clicking on the
first channel and holding shift while you click on subsequent virtual channels. After you select the virtual
channels, click Add Channel, as shown in the following figure.
Any commands sent to configure the virtual channel group are sent to the members of the virtual channel
group. For example, if a mute command is sent to Zone 1 Mics then Table Mic 1, Table Mic 2, and Table Mic
3 are all muted and the Zone 1 Mics logical group display as muted.
If individual members of a group have different values for the same parameter, such as the mute state, the
value of the group parameter displays with a crosshatch pattern, as shown in the following figures.
Polycom, Inc. 90