Dynamics Processing Adjustment
You can turn the dynamics processing turned on or off for a channel by toggling the enable button on either
the channels page or on the dynamics control highlighted on the previous figure. As with other controls, you
can configure dynamics processing for a virtual channel or a virtual channel group. When dynamics
processing is applied to stereo virtual channels, the underlying left and right dynamics processors apply the
same gain. Linked dynamics processors apply gain as though the highest level input signal were applied to
both of their inputs.
You must enable the gate, expander, compressor, limiter, and peak limiter individually with their individual
enable buttons. In the following figure the limiter is enabled.
Enabled Limiter for Dynamic Processing
After the dynamics processing is enabled, the dynamics processing curve updates as adjustments are
made to the dynamics processing settings.
Polycom, Inc.
117