Polycom SoundStructure C16 Design Manual page 229

The next step is to enter a name for the partial preset as shown in the following figure.
After the empty partial preset has been created, the next step is to add commands to the partial preset by
clicking the '+' control. This adds an empty line to the partial preset, and allow the designer to select the
parameter to adjust with this line as shown in the following figure.
Selecting Parameters
Partial presets are entered one command at a time by pulling down the appropriate parameter and adjusting
the action (set, inc, dec, tog) and selecting the arguments for the parameter.
The column headers of the partial preset may not be sorted as this would change the execution order of the
partial preset. However the column widths may be adjusted on the preset content table to allow showing the
full parameters that are being added.
Polycom, Inc. 229