Polycom SoundStructure C16 Design Manual page 389

generated. This enhancement allows both SoundStructure Studio and control system applications to know
that a preset is being executed and control system programmers can make a preset button inactive after
the initial "run" acknowledgment is received and then make the preset button active again once the final
"ran" acknowledgment has been received to prevent users from pressing a preset button multiple times for
presets that take longer to run than expected.
# Execute a preset with the "run" syntax.
run "My Preset"
# Immediately SoundStructure will send an acknowledgment that
# the preset has begun executing
run "My Preset"
# Once the preset has finished executing, SoundStructure continues
# to send the final "ran" acknowledgment
ran "My Preset"
sys_factory_reset
The command sys_factory_reset has been updated to also reset to factory defaults any SoundStructure
VoIP Interfaces that may be installed in the SoundStructure system.
set sys_factory_reset
val sys_factory_reset
A system may also be reset to factory defaults by connecting pins 8 and 9 on the RS232 interface and
applying power to the system. Once the system has finished booting, the connection from pins 8 to 9 can
be removed. The RS232 port with pins 8 and 9 shorted together is shown next.
Pins 8 and 9 on the RS 232 Interface
Polycom, Inc. 389