Polycom SoundStructure C16 Design Manual page 360

Hide thumbs Also See for SoundStructure C16:

Table of Contents

3 Create an XML file on the web server (in the c:\http\files directory in this example) in the format

shown below with at least one Phone_Image entry:

<PHONE_IMAGES>

<PHONE_IMAGE>

</PHONE_IMAGE>

<PHONE_IMAGE>

</PHONE_IMAGE>

<PHONE_IMAGE>

</PHONE_IMAGE>

</PHONE_IMAGES>

where the names UCS_4.0.1_rts30, UCS_4.0.1_rts43, and UCS_4.0.1_rts46 are directory names

that store their respective versions of the 3111-33215-001.sip.ld software files. These directories

must match the path specified in the XML file and the directories should be located in the main

directory that was configured for the web server. The contents of these subdirectories must include

the file 3111-33215-001.sip.ld that corresponds to the version specified in the software.xml file.

In this example, the web server at 192.168.1.200 has a root directory that was defined during the

installation of the web server to be c:\http\files. The directories UCS_4.0.1_rts30, etc., are

subdirectories of this root directory. In this example these directories are subdirectories of the

directory c:\http\files\.

4 Enter the IP address of a web server along with the name of the xml file that contains the

appropriate firmware versions created in the previous step in the Custom server address field.

For example: http://192.168.1.200/software.xml

as shown in the following figure.

Note that steps 3 and 4 could also use an FTP server by replacing all the references to http:// with

ftp://username:password@ in the example XML file in step 3 and in the address of the server in this

Polycom, Inc.

Troubleshooting